| Author |
Message |
    
Curt Wayne
Citizen
Username: Cswayne
Post Number: 50
Registered: 10-2002
| | Posted on Wednesday, September 10, 2003 - 5:56 pm: |     |
Hi all,
I'm building a patio. Its roughly 15ft x 20ft. I've dug my hole and leveled it and allowed for water run-off, shoveled 4 yards of 3/4inch gravel into it. Now I'm ready to tamp.
My question is: Since (incase I didnt mention it) my patio has only one 90degree corner I find it hard to set up lumber for screeding so I'm wondering if I can just check it roughly for level and do the screeding with the tamper if I start in the middle and work my way out to the edges checking with a straigh-edge and line level and 4ft level as I go along?
any pros out there or DIY'ers who have built their own patios?
Any help would be greatly appreciated.
Curt |
Curt Wayne
Citizen
Username: Cswayne
Post Number: 51
Registered: 10-2002
| | Posted on Wednesday, September 10, 2003 - 6:11 pm: | |
Oh! BTW... If you'd like to see this patio in its present state, its online at: http://www.cswayne.com/patio/patio2.html
Thanks,
Curt |
|
Closed: New threads not accepted on this page