Author |
Message |
   
tmb
Citizen Username: Tmb
Post Number: 59 Registered: 5-2003
| Posted on Monday, May 1, 2006 - 11:01 am: |
|
Does anyone know if code requires a separate kill switch (in addition to the breaker and the service switch on the furnace itself) for a residential furnace? And if so, does it have to be in a particular location? I have such a switch at the bottom of my basemet stairs that I would like to relocate or even remove. Thanks in advance. |
   
peteglider
Citizen Username: Peteglider
Post Number: 1920 Registered: 8-2002
| Posted on Monday, May 1, 2006 - 12:26 pm: |
|
Yes, it is now required, supposed to be at the top of the stairs going down into the basement. Older furnaces grandfathered in, but if its replacement -- has to be added. /p |
   
tmb
Citizen Username: Tmb
Post Number: 60 Registered: 5-2003
| Posted on Monday, May 1, 2006 - 3:02 pm: |
|
Thanks Peteglider. |
   
Master Plvmber
Citizen Username: Master_plvmber
Post Number: 530 Registered: 3-2003

| Posted on Wednesday, May 10, 2006 - 10:36 am: |
|
Actually, a remote electrical switch is only required on oil boilers. Gas boilers are only required to have a single disconnect at the appliance. Master Plvmber |
   
peteglider
Citizen Username: Peteglider
Post Number: 1943 Registered: 8-2002
| Posted on Wednesday, May 10, 2006 - 11:10 am: |
|
Perhaps codes vary by town on this. In my previous town (central NJ), a cut off switch for the gas furnace (forced air) was a requirement - at the top of the stairs. Noticed my neighbors (SO) who put in a new gas furnace had a switch like that installed with their recent new furnace (forced air). /p |